MAX4163 Datasheet

• UCSP Package (MAX4163)
• 1.0pA Typical Input Bias Current
• Single-Supply Operation from 2.5V to 10V
• Input Common-Mode Voltage Range Extends 250mV Beyond Either Supply Rail
• Rail-to-Rail Output Swing
• 200kHz Gain-Bandwidth Product
• 25µA Quiescent Current per Amplifier
• Excellent CMRR, PSRR, and Gain Linearity
• No Phase Reversal for Overdriven Inputs
• Unity-Gain Stable
• Stable with Any Capacitive Load
• Internally Short-Circuit Protected to Either Rail

• Automotive Electronics
• Cell Phones
• Cordless Phones
• Glucose Meters
• GPS Solutions
• Ionization Detectors
• IP Camera
• Low-Power, Low-Voltage Equipment
• Medical Instruments
• Panel Meters
• pH Probes
• Portable Equipment
• Power Meters
• Programmable Logic Controllers (PLCs)

The MAX4163 are dual, micropower operational amplifiers that combine an exceptional bandwidth to power consumption ratio with true rail-to-rail inputs and outputs. They consume a mere 25µA quiescent current per amplifier, yet achieve 200kHz gain-bandwidth product and are unity-gain stable while driving any capacitive load. The MAX4163 operate from either a single supply (2.5V to 10V) or dual supplies (±1.25V to ±5V), with an input common-mode voltage range that extends 250mV beyond either supply rail. These amplifiers use a proprietary architecture to achieve a very high input common-mode rejection ratio without the midswing nonlinearities present in other rail-to-rail op amps. This architecture also maintains high open-loop gain and output swing while driving substantial loads.

The combination of excellent bandwidth/power performance, single-supply operation, and miniature footprint makes these op amps ideal for portable equipment and other low-power, single-supply applications. The MAX4163 is available in an 8-pin ultra chip-scale package (UCSP™) and an 8-pin µMAX® or SO package.